I-Track Základní desky 6 a 16, SKRYTÉ NÁDRAŽÍ

IN STOCK

The pull-out holder is designed for I-Track System motherboards. The holder is supplied as a kit in three variants: for tablets, for switches and buttons, for switches, buttons and Roco / Fleischmann turntable controller. Assemble the entire pull-out holder, glue the side panels and then insert it into the grooves in the motherboard (100x80, 10x90, 120x80, 120x90, 120x100). Snap on the rear clutch and attach the front panel. You can place a tablet (max. 12 ”) on it to control the track. On another holder you can place a panel for the necessary controls - buttons, switches, etc. The entire holder is inserted in the motherboard. To operate, simply pull it out and you can ride. When finished, slide it back into the board so that it does not "interfere" and dust on it. The front plate can be easily removed so that everything you need can be installed. Then you simply place it on the pull-out holder. If you need special holes, they can be made in the panel under the tablet.

20,46€

DETAIL

Pull-out control holder-buttons,switches,turntable

IN STOCK

The pull-out holder is designed for I-Track System motherboards. The holder is supplied as a kit in three variants: for tablets, for switches and buttons, for switches, buttons and Roco / Fleischmann turntable controller. Assemble the entire pull-out holder, glue the side panels and then insert it into the grooves in the motherboard (100x80, 10x90, 120x80, 120x90, 120x100). Snap on the rear clutch and attach the front panel. You can place a tablet (max. 12 ”) on it to control the track. On another holder you can place a panel for the necessary controls - buttons, switches, etc. The entire holder is inserted in the motherboard. To operate, simply pull it out and you can ride. When finished, slide it back into the board so that it does not "interfere" and dust on it. The front plate can be easily removed so that everything you need can be installed. Then you simply place it on the pull-out holder. If you need special holes, they can be made in the panel under the tablet.

20,52€

DETAIL

Pull-out control holder-buttons,switches

IN STOCK

The pull-out holder is designed for I-Track System motherboards. The holder is supplied as a kit in three variants: for tablets, for switches and buttons, for switches, buttons and Roco / Fleischmann turntable controller. Assemble the entire pull-out holder, glue the side panels and then insert it into the grooves in the motherboard (100x80, 10x90, 120x80, 120x90, 120x100). Snap on the rear clutch and attach the front panel. You can place a tablet (max. 12 ”) on it to control the track. On another holder you can place a panel for the necessary controls - buttons, switches, etc. The entire holder is inserted in the motherboard. To operate, simply pull it out and you can ride. When finished, slide it back into the board so that it does not "interfere" and dust on it. The front plate can be easily removed so that everything you need can be installed. Then you simply place it on the pull-out holder. If you need special holes, they can be made in the panel under the tablet.

20,52€

DETAIL